# emerge-webrsync

# emerge -pv wpa_supplicant

These are the packages that would be merged, in order:

Calculating dependencies... done!
[ebuild  N    ] net-wireless/wpa_supplicant-0.7.3  USE="dbus readline ssl -debug -eap-sim -fasteap -gnutls -madwifi (-ps3) -qt4 -wps" 1,600 kB

Total: 1 package (1 new), Size of downloads: 1,600 kB

# emerge -pv wireless-tools

These are the packages that would be merged, in order:

Calculating dependencies... done!
[ebuild  N    ] net-wireless/wireless-tools-29  USE="nls -multicall" 288 kB

Total: 1 package (1 new), Size of downloads: 288 kB

make && make modules_install

mount /boot && cp /usr/src/linux/arch/x86/boot/bzImage /boot

 # iwconfig
lo        no wireless extensions.

eth2      no wireless extensions.

eth3      no wireless extensions.

tunl0     no wireless extensions.

gre0      no wireless extensions.

ppp100    no wireless extensions.

eth0      IEEE 802.11-DS  ESSID:""
          Mode:Master  Channel:0  Access Point: Invalid
          Bit Rate:11 Mb/s   Tx-Power=off   Sensitivity=0/65535
          Retry limit:16   RTS thr:off   Fragment thr:off
          Encryption key:off
          Power Management:off
          Link Quality=0/100  Signal level=-107 dBm  Noise level=-107 dBm
          Rx invalid nwid:0  Rx invalid crypt:0  Rx invalid frag:0
          Tx excessive retries:0  Invalid misc:3   Missed beacon:0

wifi0     IEEE 802.11-DS  ESSID:""
          Mode:Master  Channel:0  Access Point: Invalid
          Bit Rate:11 Mb/s   Tx-Power=off   Sensitivity=0/65535
          Retry limit:16   RTS thr:off   Fragment thr:off
          Encryption key:off
          Power Management:off
          Link Quality=0/100  Signal level=-107 dBm  Noise level=-107 dBm
          Rx invalid nwid:0  Rx invalid crypt:0  Rx invalid frag:0
          Tx excessive retries:0  Invalid misc:3   Missed beacon:0

# WI-FI

channel_eth0="6"
mode_eth0="master"
essid_eth0="HOME"

modules_eth0=("iwconfig" "!wpa_supplicant")
config_eth0=("192.168.0.10 netmask 255.255.255.0")

# dmesg
...
[218269.535440] airo(): Probing for PCI adapters
[218269.535494] airo 0000:02:0a.0: PCI INT A -> GSI 22 (level, low) -> IRQ 22
[218269.535502] airo 0000:02:0a.0: setting latency timer to 64
[218270.663076] airo(): cmd:111 status:7f11 rsp0:2 rsp1:0 rsp2:0
[218270.663083] airo(): Doing fast bap_reads
[218270.666836] airo(): WPA unsupported (only firmware versions 5.30.17 and greater support WPA.  Detected 4.25.30)
[218270.672697] airo(eth0): MAC enabled 00:0e:83:11:80:6b
[218270.676811] airo(eth0): cmd:3 status:7f03 rsp0:0 rsp1:0 rsp2:0
[218270.679746] airo(): Finished probing for PCI adapters
[218361.582707] airo(eth0): cmd:3 status:7f03 rsp0:0 rsp1:0 rsp2:0
[218470.399381] airo(eth0): cmd:3 status:7f03 rsp0:0 rsp1:231 rsp2:0
[218471.652452] airo(eth0): cmd:3 status:7f03 rsp0:0 rsp1:231 rsp2:0

# ls /proc/driver/aironet/eth0/
APList  BSSList  Config  SSID  Stats  StatsDelta  Status  WepKey

 # cat Status
Status: WEP
Mode: 200
Signal Strength: 0
Signal Quality: 176
SSID:
AP:
Freq: 0
BitRate: 11mbs
Driver Version: airo.c 0.6 (Ben Reed & Javier Achirica)
Device: 350 Series
Manufacturer: Cisco Systems
Firmware Version: 4.25.30
Radio type: 2
Country: 0
Hardware Version: 22
Software Version: 425
Software Subversion: 1e
Boot block version: 150

# cat Config
Mode: AP
Radio: off
NodeName:
PowerMode: CAM
DataRates: 2 4 11 22 0 0 0 0
Channel: 6
XmitPower: 100
LongRetryLimit: 16
ShortRetryLimit: 16
RTSThreshold: 2312
TXMSDULifetime: 5000
RXMSDULifetime: 10000
TXDiversity: left
RXDiversity: left
FragThreshold: 2312
WEP: open
Modulation: cck

# cat SSID
HOME